Topics

1

Feature Requests / control-RRC to provide +5VCC in RJ45 AUX/MIC connector

« on: 2018-02-10, 12:25:37 »

While using Yaesu rigs, if you want to use a preamplified microphone or an EQ (like EQPlus or UR6QW) power is taken from the Yaesu RJ45 Microphone. As of today it's not possible to use them without extenal mods to get power.

It would be interesting the control-RRC to provide +5VCC in the correspondent RJ-45 pin.

Best regards,

Jonathan
EA1HET

2

Hardware, Cabling, Installations / Does RRC provides VCC con control unit

« on: 2018-02-10, 00:23:28 »

Hi there,

I started a thread on the general forum and after researching a bit I think I may be close to the root of the issue. The question here is: Does the RRC control unit (the one I have close to my FT-857D frontal) provides VCC (+5V) on the RJ45 connector (labeled AUX/MIC) ?

Thanks in advance.
Best regards,

Jonathan
EA1HET

3

General discussion forum / Voice processing at control-RRC ?

« on: 2018-02-05, 13:50:16 »

Hi there,

My RRD solution is working currently with a FT-857D. I want to use my 5 band equalizer with compression (a device by UR6QW) which is a device that sits in between microphone and rig, and I thought it was not working because of the rig configuration (processor level, mic level, INRAD filter in TX). After putting all elements affecting microphone to default state I keep on having issues.

The question is: Does the control-RRC do any kind of voice handling/treatment/modification that can affect the original sound being injected by the AUX/MIC connector?

I look forward to hearing from you soon.

Best regards,

Jonathan
EA1HET

4

Configuration, RRC 1258 / USB with CAT on Radio Unit side

« on: 2018-02-03, 22:38:06 »

Hi there,

I'm new to this forum and this is my first post. My name is Jonathan, my call sign is EA1HET. I'm a happy user of the product. I have a pair of RR units working with a FT-857D, but due to the fact my shack is built I'm using them on a slightly different way than other colleagues. I've been digging for the info but I'm a bit lost. Therefore, I'm writing asking for your collaboration.

First, the question: Can I configure RR Radio Unit USB port to carry out CAT to a local computer placed in the shack?

Now, details: My shack is separated approximately 50m from my home. Between shack and home I have a fiber optic line carrying out data communications. At each extent, I have 1 RR unit (radio or control) and 1 KVM IP unit (tx or rx). At home I have a flat screen, mouse, keyboard, the RR Control Unit and the FT-857D frontal. In the shack, I have all the rest, including in "the rest" the only computer in regard to radio use.

Hope my explanation can illustrate, even briefly, the reason why I want to take the CAT signal from the RR Radio Unit to the computer. In case the above explanation is not enough I'm attaching a shack design schema. 

I look forward to hearing from you soon.
Best regards

Jonathan
EA1HET