Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - PD1IM

Pages: [1]
1
Feature Requests / startup problem
« on: 2020-12-23, 15:01:11 »
Hello

I have a boot problem with the RRC 1258MK2 on the frond side.

I had it working but after a night off the power it wouldn't boot with any possibility. after a full reset and put everything backin then it worked again but after last night without power again the same story.

If I only connect it to the USB cable on the PC, the power LED will flash slowely like normal and I can read it out, but if I connect the power it will go back to boot mode and stay try to boot upthe powertlight makes 1 verry short flas and the red/orange at the mic connector go 7seconds on,7off and when de lights go on i hear en short plop noise on the spreaker  and this repeats over en over

When I take the power off and put it back on, it finally starts up after many tries.
a short time without power is no problem and it will startup in short time same like the one on the radiosite

Somebody an idee??

73' Ingmar PD1IM

2
Hello,

I use mij 7100 with the standard handmike but like to buy the HM-151 handmike but are the DTMF buttons all working in remote?

73' . Ingmar  PD1IM

3
General / TS2000 remotehead + Nano app combi??
« on: 2019-02-23, 12:34:19 »
Hello,

Is it possible to use de ts2000 with a rontrol head and also the Nano app (not at same time) so i can use the remotehead on my work
and te app when i'm in the car or wait someware or is only one  of the 2 at the same time posible?

73' , Ingmar

4
hello all,

I try now for 3 days to get my icom 706 get work with remoterig but nothing goes on. 
i do something wrong i think but no id what.
when i connect the cables whit the rj45 connector the 706 works fine so the cable must be good

do somebody have the setting files for me or can somebody help me with teamviewer ???

73'  Ingmar  PD1IM

5
Hello,

i am new on this forum and trying to connect mij icom 706MK2G with remoterig.
i mad the connection cable for both sides and when i connect them tougether with jt45 connector the set works so the cable must be OK but Do i have to connect the radio and control head of mij icom 706MK2G to both boxes while configuration or first configurate an then connect?

thanks,   Ingmar

Pages: [1]