Topics

1

Configuration of Routers, Firewalls, etc / Configuration help through PTP system

« on: 2021-11-12, 00:44:49 »

Hello folks:

I have had great results allowing a friend to remotely connect to my shack using a more conventional setup (see attached pdf). However, I recently moved the radio equipment to an outbuilding which is connected to by house (location of former working system) which is connected through Ubiquiti Loco M2 PTP system. The attached pdf show both the original, working and updated systems.

Question: has anyone successfully configured a Remote Rig system similarly and could give me some pointers or see where I'm going wrong here?

Your help is much appreciated!

2

General discussion forum / RRC with IC-7100 will not connect

« on: 2021-03-25, 15:42:24 »

Hi:
New installation using two RRC-1258 MkII with new IC-7100 has never connected. Directly connecting radio to Icom control head works correctly.

Configured Radio side as IP 192.168.1.102 and control side as 192.168.1.103. Circuit board plugged correctly into control side and jumpers installed (and rechecked) into RRC on radio side. Both control and radio RRC connect to my router and I'm able to set all parameters using web-based browser.

Radio and control sides "Radio settings" are set as prescribed in manual and confirmed

IP settings:
IP settings Unit ID (Banner) Remote Rig Radio Side
DHCP No
IP 192.168.1.102
Netmask 255.255.255.0
Gateway 192.168.1.1
Dns server   192.168.1.1
Eth-type   Auto, prefer 10 Mbit
IP-interface Auto, prefer Ethernet
Web page user   
Web page pwd   
 Show
Web page user(saving)   
Web page pwd(saving)   
 Show

Router configured to redirect

Local LAN Ports      Local LAN IP Address                        Protocol    WAN Ports                  Remote IP Address   
80 to 80              192.168.1.102                                        TCP            80 to 80                          All IP Addresses   
13000 to 13002      192.168.1.102                                       UDP            13000 to 13002          All IP Addresses   

Status:
Name   Value
P5.2   OFF
Connection status   Disconnected
SIP status   Idle
Last SIP error   None
RTP/UDP audio status   Disconnected
UDP cmd status   Disconnected
SIP command timeout   0
Rx Jitter buffer size   4
Rx Jitter delay   3
Dual Rx   0
SIP Out port   13000
SIP In port   13000
Audio Out port   0
Audio In port   0
Command Out port   0
Command In port   13002
External SIP In port   13000
External Audio In port   13001
External Cmd In port   13002
Other party   0.0.0.0
Input 1   Low
Input 2   Low
Output 0   Low
Output 1   Low
Output 2   Low
Dynamic DNS status   Unknown
Ping status (watchdog)   OK [5 ms]
DNS status   OK, remoterig.com = 213.180.92.125
Active profile   Default
PTT status   OFF
Antenna-Switch (IP)   not connected
Common network settings   No


I can supply any additional information as require to get this project up and going. Thanks so much!

Jerry, N4KJ