Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - SA0TJS

Pages: [1]
1
Hi!

I am trying to set up remote rig  according to the above configuration. All seems to be set up correctly.  The ddns information is recognized by the controller (panel) side, i.e. the host address is shown in the status information on the controller!

So the LAN/network should be Ok but still the communication  between the controller and the host (radio) is not working. When I press the power button a peep sounds after a while. I have checked the SIP passwords, they are equal.

When i connect the controller directly to the tp-link router (to same LAN as the radio) it works ok.


What more can I do/check.

73 de Björn

2
Hi! Anyone who knows if this is possible? Cables are built according to available drawings.
I have tried almost every combination of the IO port settings. I got this suggestion from SM0CXU who has the latest Mark II version:
Control panel side:
INO Mode: I/O
Out 0 mode: Connect
Out 1 mode: I/O
Out 2 mode: Keyer
RTS Disabled
DTR Disabled


On the radio side I have tried almost every combination.

What happens is the output either is dot dash dot dash etc ... independent of which paddle I press, or with some I/O combinations I get either only dots or only dashes independent of paddle pressed.

I get the impression that connection over the rrc is not capable of separating the dot line and the dash line   which results in that signals are treated as a squeeze of both paddles which is not the case.

My radio is Kenwood  TS480 SAT

Any ideas?


Pages: [1]