Show Posts
1
General discussion forum / TS480 SAT 95% no Audio via RRC boxes
« on: 2025-08-05, 22:26:48 »
Dear friends,
Today I was busy with setup my RemoteRig with TS-480 SAT and faced issue - everything seems to be OK, I was able to start my Kenwood through remoterig boxes, but only issue no RX/TX sound. I would say that may be in 5 % cases it have started normally with sound both ways. I have 2 pairs of RemoteRig and replaced and setup each side, but result is the same. So this is not hardware issue. Did somebody fight with same? I use on the radio side 4G router with wireguard connection to droplet with external fixed IP with all ports forwarded. Strange thing is that it's sometimes working, sometimes not. All settings according to manual, I played with codecs bandwidth, levels, but still no success. Thanks for any ideas, advices.
73!
de UR5FLN
Sergy
Today I was busy with setup my RemoteRig with TS-480 SAT and faced issue - everything seems to be OK, I was able to start my Kenwood through remoterig boxes, but only issue no RX/TX sound. I would say that may be in 5 % cases it have started normally with sound both ways. I have 2 pairs of RemoteRig and replaced and setup each side, but result is the same. So this is not hardware issue. Did somebody fight with same? I use on the radio side 4G router with wireguard connection to droplet with external fixed IP with all ports forwarded. Strange thing is that it's sometimes working, sometimes not. All settings according to manual, I played with codecs bandwidth, levels, but still no success. Thanks for any ideas, advices.
73!
de UR5FLN
Sergy