Topics

1

General discussion forum / Repair of 1258

« on: 2015-08-20, 22:56:07 »

I have 2 1258MKii s/n 3433 and 6422. Both have been damaged by reverse polarity power supply. Is there a repair facility? Is it worth the effort?

2

Configuration, RRC 1258 / K3-0 MINI

« on: 2014-09-24, 14:37:19 »

I have been using 2 K3-100 FB for 2 years. Decided to get a K3-0Mini. Put in place of the -100 . It hooks up but when I use N1MM no freq indication on the computer and message saying com 6 not connecting. Swap back to -100 and all is well. Com speeds all the same etc. Any ideas out there before I start changing stuff?
Tnx
Jim K5AUP

3

General discussion forum / Hot spots

« on: 2014-03-13, 03:14:04 »

My Twin K3 control setup works great if I use my Verizon hot Spot but has lots of skips and blanks when I use my AT&T hot spot. These are separate units not on my phone. The Speakeasy.net shows 3 times the speed on the AT&T as the Verizon. I get 4GLTE on the AT&T and 4G on the Verizon. I'm using over the air internet service at the remote with a fixed IP and 3 up and 3 down speed. any Ideas or comments. I have enjoyed this setup greatly and appreciate the tremendous support of the forum.

4

Configuration of Routers, Firewalls, etc / I Phone hot spot

« on: 2013-02-01, 18:41:48 »

I have my K3 Twin setup working Fb on the Lan. I can change the RRC radio setting to my fixed IP and go to an outside hotspot and all works fine. If I try to use my Iphone as hotspot (3G) it will turn on the K3's but no audio or other functions work. The Iphone hotspot will work ok using it to work my laptop. I also tried using my WNCE2001 into the ethernet conn on the RRC and Iphone hotspot same result. I have the wireless mod on my control RR. It sees the wirless signals and I can select etc. The Wnce setup will furnish connection to my laptop though. I've tried combinations of power on-off, reset, Off and on with the hotspot etc. The other screwy part is the Iphone-WnCE2001 combo worked fine during Christmas holidays on my Icom 7600 RR setup.
Any Ideas out there?
Thank you
Jim
K5AUP

5

General discussion forum / getting started

« on: 2012-05-05, 14:24:38 »

I have a remote rig 1258 set upand running. I bought a 1216H to control power in the shack. I can't find info needed like do I put my fixed IP into the IP slot as I did on the 1258?. What software on the distant computer to control the webswitch.  The switch is working FB on my LAN. Do I just put in the fixed IP or just port forward the existing switch IP?

Thank you
Jim
K5AUP

6

General discussion forum / Icom 7600

« on: 2012-03-20, 02:54:14 »

Anyone using RR withthe Icom IC7600 and it's usb port??
Tnx

Jim
K5AUP