Messages

1

General discussion forum / Re: no virtual com ports

« on: 2012-02-29, 07:26:41 »

Hi Jan, yes, thats a different issue, and after reading my post, I see I make no sense ! thats what I get when I am really tired ! don't even make sense to myself let alone anybody else !  so to answer your question, I do not know what service pack version is on my XP, how can I look that up ? I have gone to the windows update site and downloaded all of there latest updates.

2

General discussion forum / Re: no virtual com ports

« on: 2012-02-27, 16:54:37 »

Yes, have installed setup manager, can talk to each indivual 1258, but have not been able to get them to connect to each other, maybe a setting wrong ??  thanks ...ken

3

General discussion forum / no virtual com ports

« on: 2012-02-27, 03:39:20 »

Hi All,    I have downloaded the latest firmware via web updater, and can access both RRC-1258's via browser, but so far have not been able to get them to start together, one problem I am see via the Hardware manager is none of the virtual USB com ports are working, just the usual "?" in front of the RRC1258 COM0 (com9)  alongwith with com1,com2,comfsk, with the comment "this device cannot start code 10"  have tried unistalling and reinstalling, no luck yet,  anybody have any ideals ?? using a laptop with Windows XP                thanks..... Ken

4

Configuration, RRC 1258 / Re: firmware update

« on: 2012-02-26, 23:39:53 »

after a bit of searching and reading, now have units updated via web, thanks... Ken   K7ZUM

5

Configuration, RRC 1258 / Re: can not update firmware

« on: 2012-02-26, 21:56:15 »

having the same problem, ver 2.33,  so next question is, how do you update using the internal web page ??

6

Configuration, RRC 1258 / firmware update

« on: 2012-02-26, 21:08:47 »

Hi All, trying to update firmware to my 1258, using laptop, have usb cable plugged into 1258 to usb port on laptop, setup manager says all is working and connected, go to load lastest firmware, and stops with  error 31, suggestions ??  also in device manager it shows a question mark under ports with this being  the line   RRC1258 COM2(COM8)    under properties, the comment is "this device cannot start (code 10)   any suggestion ?  using windows XP, and installed netframework 2.0   thanks... Ken K7ZUM