Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Mirek SP1NY

Pages: [1]
1
Thanks for prompt reply Mike.
Looks like I can make it but must run some test on site
to check quality and speed of ADSL.
Here in SP-land in rural areas, as mine, ADSL bandwidth  is often limited.
I bought this property a few days ago so don't know yet what is the situation,
but reach at least 2-3 Mbit/s shouldn't be a problem.

73, Mirek SP1NY

2
Hi, Mirek SP1NY here.
Most probably I will start my adventure with remote this year.
First step will be with TS-480 but want to develop system to two Yaesu twins in SO2R configuration later.
At remote site have ADSL with 5MB.
I'm wonder if it's enough to transfer all needed audio and control signals???
On the other hand I can run major contests directly from remote site as
it's located only 30 km from my home.

73, Mirek SP1NY

 


3
General discussion forum / Ultrabeam remote control
« on: 2012-08-02, 13:57:26 »
Hi,
I'm newbie to this forum so hello to everybody.
Just started to think about my own project of remote control station.
Presently I have FTDX-5000 + Yaesu FL-7000 + Ultrabeam UB 50 ant + some MicroHam boxes.
Puting, for a while, radio and PA aside - it's posible to remote control of Ultrabeam antennas by means of using 1216H???
I dont know if Ultrabeam is using the same control protocol as is with Steppir???

73, Mirek SP1NY


Pages: [1]