Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - N0ECT

Pages: [1]
1
General discussion / Re: Microbit RRC Client - won't connect
« on: 2013-10-12, 22:19:39 »
Thanks Charlie.

I connect to the remote network  10.0.3.0  (where the TS-590 is connected to the RRC-1258 (on COM2) via a VPN connection from my Win7 PC.
So once the (PC to LAN) VPN is connected, I'm on the same network (10.0.3.50) as the TS-590 at 10.0.3.13...  My PC and the Radio can "see" each other directly since they're on the same network after the VPN connection is made...

There isn't (as far as I know) any requirement to forward an IP ports - since I"m on the same network.  Yes, my Win7 PC has the windows firewall turned off.

Other ideas?

2
General discussion / Microbit RRC Client - won't connect
« on: 2013-10-12, 20:54:47 »
We have (2) RRC-1258 MkII boxes connected and working from (2) different remote IP Subnets.  It works controlling my Kenwood TS-590, just like the book says.

The remote TS-590 Radio is directly connected to the RRC-1258 at (10.0.3.13)  (COM2)
My PC with the Microbit RRC client refuses to connect to 10.0.3.13

From my PC (that is VPN'd into 10.0.3.0) I can open the browser and look at 10.0.3.13 and review the settings there.
At 10.0.3.13 are:  (I have made my RRC PC client settings match this)
SIP Port:  13000
Web Page:  80
Password:  hello
Audio Port:  13001
Command Port:  13002
Jitter size:  4
Jetter Delay:  3

I have made a 4 page PDF file of my settings and connection failure.
If my client PC can connect via a web browser, why won't my Microbit RRC client?

Pages: [1]