Messages

1

Configuration, RRC 1258 / Re: RRC Winkeyer and N1MMPlus

« on: 2015-06-14, 19:20:35 »

Have problems getting N1MMPlus to identify Com3extra and configure Winkeyer for CW.  I had it working a few weeks ago and after 3 hours a trying to get N1MM to configure it I'm not sure what to do.  I did move to the new 2.85 firmware and the configuration is a little difference in the I/O setting than I remember.  Can someone give me some leads or the new settings?  I using a K3/mini and a K3 with 1258 MKII twins.

Thanks and 73 Bill   W4RM

2

Configuration, RRC 1258 / Re: Remote Rig Winkeyer and N1MMPlus

« on: 2015-01-25, 14:44:12 »

What is the proper set-up configuration for Winkey?      (I'm using K3/0 Mini with 1258MKII twins, laptop at the control side with N1MM+ and K3 K-line at the remote site (Local LAN at present).

Install at the Control or remote site?

Install Winkey on COM 1 , 2 o3 ... doesn't matter?

What is the main reason for using winkey?      Is it to get N1MM (from control side) to send the data across the network and get the remote side Winkey to generate the CW?   By getting the remote side to generate the data to ensure purity of the CW being transmitted?

I'm ran the 160M contest over the weekend with the above set-up and had lots of people send me their callsign again as what I sent them was incorrect, I did copy it correctly, (CW was being generated from the control side laptop on the KAT port within N1MM+).

I'm assuming this is what driving people to install the Winkey?

Thanks for everyone's help

73 Bill  W4RM

3

Configuration, RRC 1258 / Re: Remote Rig Winkeyer and N1MMPlus

« on: 2015-01-24, 20:07:34 »

Which is the prefer side to install the winkeyer?  Remote or control?

My control is currently sending the CW via the CAT port and its not perfect.  I want to install my winkeyer back into my remote set-up that it was remove when I configured the K3 for remote.

Will this help my control side CW that's being transmitted?

I was running  a laptop and N1MM+ last night in the 160M contest and I we repeatedly sent the other person call sign as if I send it back in my exchange incorrectly.  By changing the delay settings and moving up to 30WPMs it seemed to help but I'm hoping that the winkey will also help on the remote side.

Thanks for any help
73 Bill  W4RM

4

General discussion forum / Re: Remote Rig setup using K3 mini Control and K3 at Remote site

« on: 2015-01-24, 19:56:55 »

Can I get a copy of the checklist as well?  W4RM@aol dot com

Thanks 73 Bill  W4RM