Messages

1

Configuration, RRC 1258 / Re: Config for IC7600 1K Steppir & M2 2800?

« on: 2015-06-21, 19:53:56 »

Thank you Mitch.
This is the info I have been looking for and especially the info on the serial servers. I was trying to avoid using them but I see that full control is better accomplished (and interface capability) using them.
I will continue my searching and will also seek out the info you have mentioned that is already posted on this site as well as the 3rd party device manufacturer's sites.

Thanks to everyone for their help

Bob K8NY

2

Configuration, RRC 1258 / Re: Config for IC7600 1K Steppir & M2 2800?

« on: 2015-06-20, 00:03:08 »

Thanks guys, I appreciate your responses.
Yes I have been looking at software options and I have a demo copy of TRX Manager on my PC and I have used it.
I have also looked at N4PY software and it is very interesting.

Let me further state my requirements:

I do not want to run a PC at my site for the length of time I will be away (3 months)-
I am considering RemoteRig RRC 1258MkIIs with RRC-Micro PC-Client.
I would like to know the amount of RS232/COM ports available from the RRC 1258MkIIs - again I need control of Expert, Steppir & 2800 Rotor.

I prefer using the RemoteRig solution vs a pure PC software solution.

Thanks

Bob

3

Configuration, RRC 1258 / Config for IC7600 1K Steppir & M2 2800?

« on: 2015-06-17, 15:38:47 »

Hello everyone,

Well, I have been reading here a bit and I am now ready to pose my question.
Using RemoteRig products, what is a recommended hardware configuration for the following setup:

Icom 7600
SPE Expert 1K
Steppir Controller
M2 Orion 2800 rotor

From reading previous posts, it seems there may be several ways to accomplish this. I am open to any configurations.

Thanks so much

Bob - K8NY