Messages

1

Hardware, Cabling, Installations / Re: Help with Yaesu FT-857 and RCC-1258 MkII units

« on: 2016-11-01, 20:12:51 »

Hello,
I built the cables according the pages 158 and 159 of the following link:

http://www.remoterig.com/downloads/RemoteRig_RRC1258-MkII_Users_manual.pdf

I have a powersupply only for the body the Yaesu FT-857 and the RRC-1258MKII control unit and RRC-1258MKII radio unit have their own power supplies.

Besides, I sent you the exported settings (html) files at your email from qrz.com

Best regards,

2

Hardware, Cabling, Installations / Re: Help with Yaesu FT-857 and RCC-1258 MkII units

« on: 2016-11-01, 16:13:57 »

Hello again.
I have already made the settings on the control unit and radio unit as you can see in the attached pictures, but it does not work.

In local mode when I try to start the Yaesu FT-857 only the yellow LED lights a moment in the AUX connector of both units and I heard noises like relays. Any suggestions?

3

Hardware, Cabling, Installations / Re: Help with Yaesu FT-857 and RCC-1258 MkII units

« on: 2016-11-01, 15:15:37 »

It is true, on the label on the bottom indicates RRC-1258MKIIs V7
Thank you very much Mike.

4

Hardware, Cabling, Installations / Re: Help with Yaesu FT-857 and RCC-1258 MkII units

« on: 2016-11-01, 14:33:35 »

Ok but my units are model RCC-1258 MkII without S. This difference is not important?

5

Hardware, Cabling, Installations / Help with Yaesu FT-857 and RCC-1258 MkII units

« on: 2016-11-01, 14:20:26 »

Hello to all:
Thanks for reading this message.
I have two units RCC-1258 MkII (IMPORTANT: it is not the unit model RCC-1258 MkIIs) and as indicated website in
http://www.remoterig.com/wp/wp-content/uploads/2012/02/YAESU-FT-857-10a-10b.pdf is possible works with a Yaesu FT-857 making cables Y10a and Y10b but in this pages only appears cables Y10b. I guess that will be a little mistake, all right?

On the other hand, in website says that “Modify RRC-1258MkII of versions 3,4,5,6 for the FT-857” but my unit are RCC-1258 MkII with version 7 that you can see in the image attached. It is possible to work with this???

Finally I built the wires and I'm testing in local mode but the Yaesu FT-857 doesn´t start although the power supply is independent of the both units. Only lights a yellow light in the AUX connector when I try.

Please, I need your help.
Best Regards,
Jesus