Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - G3VKM

Pages: [1]
1
OK Mitch,

e-mail sent.

73

Roger/G3VKM

2
Hi Mitch,

OK, nothing changes on the Status page of either of my RRCs when I press the power button on the IC-7100 control head.

73

Roger/G3VKM

3
Sorry! For "lead" read "head"!

Roger

4
Hi Mitch,

Pressing the power button on the IC-7100 control lead does nothing, the radio doesn't power up. The yellow LED on the Control RRC starts flashing and stays like that until I power down/up the RRC. The green power LED is steady after a few seconds at power-up.

Any advice much appreciated,

73

Roger/G3VKM

5
Hi All,

Thanks for letting me join the forum.

I bought an IC-7100 back in May, it's a great radio but I had very little success with the RS-BA1 software. After a break of some months I decided to get a pair of new Remoterig boxes and try again! The boxes arrived yesterday and I soon had both of them talking to my home network via the router. What I don't seem to be able to do is connect the two boxes together, I get no "power on" from the radio control head at the house.

According to the manual, the status page in the MicroBit set-up manager program should show me a "Connect" button but this isn't present on either the radio box or the control box menus.  Anyone on the forum who could talk me through setting up? I am confident that I have the internal links and jumpers set correctly and both boxes are version 7, which I am told is the latest edition. I want to use a basic set-up, just the radio in the outdoor shack with 30m CAT-6 cable to the house where the radio control head will be located. Not interested in using the system over the internet until I get the basic station going.

73

Roger/G3VKM - Norfolk, England.

Pages: [1]