16
General discussion forum / Re: Remote Rig Newbie-IC7000 TX audio problem
« on: 2012-04-29, 19:07:23 »
Hi Mike,
Thanks for the reply -----You are right - I had the pin diagram inverted!! I now got the correct pins connected and all functions work with HRD BUT I still cannot get PTT with TX audio from the mic. If I press the TX button on the HRD 7000 panel, it keys the TX but no audio from the mic. I have tried the standard HM-151 with Jump 1 in place and with the Heil Elite headset with Jump 1 removed.
I had to change the SIP port to 5062 on both Radio and Control RRC as my router is using 5060 for internet telephony.
Are there any software settings in Radio/Serial/Advanced that would affect the TX audio? I have attached Radio/Serial/Advanced settings for Radio and Control RRCs
Thanks again Mike - best 73
Geoff
G8OFQ
Thanks for the reply -----You are right - I had the pin diagram inverted!! I now got the correct pins connected and all functions work with HRD BUT I still cannot get PTT with TX audio from the mic. If I press the TX button on the HRD 7000 panel, it keys the TX but no audio from the mic. I have tried the standard HM-151 with Jump 1 in place and with the Heil Elite headset with Jump 1 removed.
I had to change the SIP port to 5062 on both Radio and Control RRC as my router is using 5060 for internet telephony.
Are there any software settings in Radio/Serial/Advanced that would affect the TX audio? I have attached Radio/Serial/Advanced settings for Radio and Control RRCs
Thanks again Mike - best 73
Geoff
G8OFQ