16
General discussion forum / Re: Micro PC, TS-480 and Bandmaster III?
« on: 2012-07-27, 19:19:57 »
I'm using COM2 for the rotor control. I'm not using COM 1 port on the radio RRC.
I'm confused on this. It appears that you are saying that I connect the TS-480 CAT to COM1 on the radio RRC and then connect the Bandmaster - but how? USB? Are you suggesting that in Mode 6 the radio RRC becomes a serial splitter, of sorts?
Quote
If you are not using COM1 on the RRC, then just loop back the CAT through COM1 and connect that to
the band decoder. You place COM1 in mode-6 and make sure you pay attention to the pinout on COM1,
since it is a mirror image of COM2.
I'm confused on this. It appears that you are saying that I connect the TS-480 CAT to COM1 on the radio RRC and then connect the Bandmaster - but how? USB? Are you suggesting that in Mode 6 the radio RRC becomes a serial splitter, of sorts?