Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Ron Leech ve7nex

Pages: [1]
1
General discussion forum / kenwood TM-D710
« on: 2014-12-14, 19:23:19 »
I have A TK-480 working Perfect for over a year and now I would like to set up my D710 on a new set up. I would also like other Hams use it What all will I need to set it up and is there a good program to operate it Like the Kenwood ARCP-480 program. I also would like the new NANO to run it if it could. Any help would be appreciated.

2
General discussion forum / Grounding the RCC1258
« on: 2014-02-10, 20:05:19 »
Should the RCC1258 radio end be grounded to station ground to help keep out rf and static buildup if so how would I without drilling holes?


3
It look like it was the New beta Elecraft remote program that is to blame. It works just fine with the utility program control 

4
I Have lost all control of my kpa500 on com 2 it only worked for a short time. I would like to use it on com1 but cant get it to work on 1 or 2 . I was told buy Elecraft to put the new Beta firmware 1.29 but still will not connect If you have it working can you please help by sending me some settings. Also are you using a male to male straight db9 cable from KPA500 to com1 I found it hard to find the cable so I'm using a male female with a male male adaptor could that be the problem?. Any help will be appreciated 

5
Configuration, RRC 1258 / Full control of KPA 500 on com1
« on: 2013-05-29, 01:23:15 »
Elecraft now has a new program to remote the Kpa500 and the KAT 500 and works good with full control

6
Configuration, RRC 1258 / Elecraft KPA500 on com1?
« on: 2013-05-27, 00:48:11 »
Can the KPA 500 Utility run thew the rrc 1258 on com1 0r com2 to turn it on, off and reset the amp remotely. If some one can be of assistance to help with this it would be greatly appreciated I have read all that my brain can handle and just can't figure it out. 

7
General discussion forum / Re: ts480 noise
« on: 2013-05-20, 07:05:07 »
Found the problem I moved the control head into the other end of the house an all ok now must be rf getting into the internet and feeding back into the mike

8
General discussion forum / remote camera on rrc
« on: 2013-05-20, 06:33:16 »
I have a rrc MK11s and it wood be nice to see the tuner, amp, DCV  the out put power swr or faults on the amp so my question is can a web cam (usb) or other run threw the rrc in a small window on the computer to see or am I dreaming.

9
General discussion forum / dns
« on: 2013-05-16, 16:27:09 »
How do I get started with remoterig dns and do I need to sign up if so how Im new to all this kind of equipment and not to good with the ip stuff

10
General discussion forum / Re: ts480 noise
« on: 2013-05-12, 04:22:00 »
Thaks I will give it a go

11
General discussion forum / ts480 noise
« on: 2013-05-12, 03:49:06 »
I just tested my new remoterig with my 480 and I have a back ground noise like a motor boat so I was told any sugestions all worked ok other than that

12
General discussion forum / Commercial radio
« on: 2013-04-28, 18:55:34 »
Will the RRc-1258 Mk11  Commercial Work with a Kenwood 7180 or 8180  Commercial Radio

Pages: [1]