Messages

31

General discussion forum / Re: Problems connecting a TS-2000 through HRD

« on: 2010-11-06, 00:15:11 »

Hi Lars and rest of OM's,

Have been all week out and I've found now the answer from SM3CCM: that's right! I'm on the air again!

My only comment is that I had to change COM2 serial settings in both the control and the radio side.

That's working fine now.

Lars: how did you guess that?!

I think that RRC's are a terrific product. I'm really in love with it. But "communication" or, say, "instructions" are an "opportunity to improve" (as a customer from me likes to say).



Tks & Bst 73!!

32

General discussion forum / Problems connecting a TS-2000 through HRD

« on: 2010-11-03, 00:29:12 »

Hi OM's,

I've been the last two days puzzled here around a connection problem with my remote TS-2000. That's driving me crazy!

I've got a proper connection between both two RRC's with a "connected/transferring" SIP status.

I even have a complete connection to a ProSisTel rotor through the COM1 front connector. I mean I'm able to remote control a ProSisTel rotor at the radio site.

But, when trying to connect to TS-2000 through HRD, no way!! Always HRD refuses to make the connection.

I've got that fatal message: "TS-2000, COM5, 9600, Failed to read frequency".

I've tried different com ports, different baud rates, all the possible combinations of CTS, DTR, RTS...

Let me say I've been working ok the last months. I don't know how this has started. I can only say I upgraded to firmware 2.26 at both sides. I have revised all the data and magnitudes 100 times...

Today, I've been on the radio side and I've checked a direct HRD connection and it has worked.

I also have checked with other programs at the control side here: TRX, ARCS. No result!

Has somebody experienced something similar?
Any idea?
Maybe is there something wrong with the unit?? How could I check it!?

One more information: I also have a RRC-Micro PC-Client and I've got the same situation...

Tks & 73!

EA3GEO, Daniel

 

33

General discussion forum / Re: Software control side

« on: 2010-03-15, 14:11:45 »

Hi there!

I've read this post with much interest.

If that could be done, the product would be really unbeatable...

I wonder if a "double set" could be configured:

I mean the RRC connected to the radio and, at the same time, the radio also connected
to a PC, via the RS232 radio port, and the audio cables to the sound card in a way that
we could either use the RRC (as it has to be!) or accessing the radio and its PC via HRD
remote working then with Skype when in the hotel or the airport without the RRC.

That could be the case of a TS-2000 with the remote head connector and a RS-232 port?

I don't know if I have explained well myself...

73 ES GD DX DE EA3GEO, Daniel