Messages

46

General discussion forum / Re: Losing connection

« on: 2019-06-09, 23:40:23 »

Thanks i have tried all that you have said. The highest power i can work from radio is 30 watts at the moment. Will try next weekend with second Sat from car to if maybe problem is from the the Remote Kenwood.

73s Gary

47

General discussion forum / Re: Losing connection

« on: 2019-06-09, 18:35:26 »

Hi Mike many thanks for reply, the RRC Control shows red light and also face of kenwood 480 Sat, i am not sure if the RRC Radio side shows red unless i ask my friend to have a look the next time it goes down. 

Both antenna are OK and have tried different Mic's and power cables to RRC Control. Also noticed that my ddns.remoterig.com page does not show for some time after going down. Both boxes are the latest build.

Many thanks
Gary

48

General discussion forum / Losing connection

« on: 2019-06-09, 01:39:20 »

Hi there can anyone help me out, for some reason each time i key the microphone the red light flashes and shows like the microphone is pressed on the Kenwood 480 Sat.

All the jumpers on both boxes have not been changed in any way.  I have tried two different power supplies to each boxes and also 3 different microphones with no joy.

Any help would be greatful

Gary

49

General discussion forum / Rotator advice

« on: 2019-04-19, 03:17:38 »

Would anyone know if this small light duty Yaesu G 450C Rotator would be OK to control the 1.5 meter 3 el Yagi or would i need to go for stronger for the lightweight Yagi

Many Thanks

50

General discussion forum / Re: RTL-SDR V3

« on: 2019-04-15, 22:26:46 »

Ok mike many thanks.

51

General discussion forum / Re: RTL-SDR V3

« on: 2019-04-15, 19:58:34 »

Hi Mike what i have built from inside the radio to PC to dongle and works.  Just need to know if it would work remote.

https://www.ebay.co.uk/itm/RTL-SDR-Blog-V3-RTL2832U-1PPM-TCXO-HF-BiasT-SMA-Software-Defined-Radio/272411458376?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649

https://www.ebay.co.uk/itm/USB-2-0-A-Female-TO-RS232-DB9-Female-Serial-Cable-Adapter-Converter/272805994084?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649

73s de Gary

52

General discussion forum / RTL-SDR V3

« on: 2019-04-15, 10:02:08 »

Hello there would anyone know if possible to work both RRC-1258MkIIs and Kenwood TS 480 to RTL-SDR V3 RTL2832U. The cable has been already installed inside radio to RTL-SDR before but now would like to work with remoterig.

If this is possible to do on COM 1 both boxes how would I have settings in Serial settings in both Radio and Control side and is there anymore changes needed in settings.

Many Thanks

53

General / Re: RRC Kenwood Nano "license expired"

« on: 2018-12-20, 04:02:14 »

Still never worked Nano, could not get RRC both sides to work until the great help from Mitch.

Tried to install this a few times and test the Nano out sure it says that it was expired now

Wish you all the best with it 73s

54

General discussion forum / Re: Lose connection with radio side

« on: 2018-10-01, 23:22:03 »

Hi Mitch,

No the problem is from Control side at my home, when it goes down i try rebooting first from the bottom of page but does not work.
I can see the web page OK fine the control side.

At the radio page this seems to go down when the radio is not working and only shows after rebooting again in the farm. this is the only reason i ask for help at radio side, Will try copy problem next time down Mitch.

73.
Gary

55

General discussion forum / Re: Lose connection with radio side

« on: 2018-10-01, 07:28:39 »

Hi Mitch,
I have notice at first it sounds like a bad connection between my home and where radio side is located.
This has been installed again for over 5 weeks and seems to go down always before the weekend and need to for help at Radio side.
I can see the status page OK but did not copy what was shown when RRC dies.
Have tried from the connection at my home and also from my mobile O2 Wifi that works OK when away from home.
This has to be reboot from his home as RRC Radio is located outside in the farm and he can't see box flashing.

73,
Gary

56

General discussion forum / Lose connection with radio side

« on: 2018-10-01, 05:36:17 »

Can anyone help me out i always seem to lose the connection with RRC Radio side and have to ask my friend to turn off and on again for control to find TS 480 Sat.

57

General / Re: RRC Kenwood Nano "license expired"

« on: 2018-09-25, 19:12:14 »

Yes still the same here i did not get the chance to test it out to see how this works out.

58

General / RRC Kenwood Nano "license expired"

« on: 2018-08-14, 02:40:20 »

Hi there,

can anyone tell me is it possible to renew the Kenwood trial period, never got chance to work this here when Remote Rig was not working for over six months.

Message says trial period stopped by the expire. Can you tell me if this is possible to be fixed with Lic.ID 6d98 or would i have to try install fresh again.

73 de Gary

59

General discussion forum / Re: Kenwood 480 Sat connection problem

« on: 2018-06-16, 20:38:22 »

Hi there,

Finally got both boxes to to be seen at radio side and work ok as a test. But for some reason can't find at now.

Would anyone have any ideas how i cant find the radio side or is there maybe a fix in RRC Control or Radio side.

Best 73s

60

General discussion forum / Re: Kenwood 480 Sat connection problem

« on: 2018-06-16, 01:02:44 »

Thanks Mitch,

Will try and visit radio side today and change the two jumpers about shown in picture.  Hopefully this will solve my problems here with newer version of TS 480 Sat

Best 73s
Gary