Messages

46

Hardware, Cabling, Installations / Re: RRC 1258 and IC7100 front panel power supply

« on: 2015-11-04, 13:55:28 »

Much better 12V because it is easiest to find commercial power supply than 13,8 module.
Many thanks

47

Hardware, Cabling, Installations / Re: ic7100 and HRD deluxe

« on: 2015-11-04, 13:54:20 »

Thank you for reply. But only if I use a CV-I connection or what?
Can I just remove the rj45 cable and use the usb from the control side?

48

Hardware, Cabling, Installations / ic7100 and HRD deluxe

« on: 2015-11-03, 16:34:12 »

Hi, i looked around but I couldn't find anything about the possibility to interface the Control RRC (with or without the ic7100 front panel attached) to HRD deluxe or other similar software. Any hint for this?

49

Hardware, Cabling, Installations / RRC 1258 and IC7100 front panel power supply

« on: 2015-11-03, 15:51:51 »

Hi, I just read in the instruction that the suggested voltage for supply both of two is 13,8V 1A.
Anyone tested successfully a power supply of 12V ? there is any possibility of burn something?
Regards