Messages

16

General discussion forum / Re: Winkey on COM1

« on: 2017-01-31, 09:35:56 »

Mitch,

You perfectly explained my question !

I made several tests, and i'm sure it doesn't work...

73, Patrick

17

General discussion forum / Re: Winkey on COM1

« on: 2017-01-30, 18:38:33 »

So far no luck with an answer.
A private mail to SM2O didn't help either..

73, Patrick

18

General discussion forum / Re: I/O settings for K9AY

« on: 2017-01-25, 20:42:43 »

How many I/O do you need ?
I'm not a specialist, but i see in the manual that you can use OUT and OUT2 on the RADIO side and that they follow IN1 and IN2 on the CONTROL side.

73, Patrick

19

General discussion forum / Re: Winkey on COM1

« on: 2017-01-24, 21:50:46 »

OK Mitch,

I tried COM1 + Winkey, but that doesn't work in the way i think...
COMEXTRA works perfectly, so there is something i don't understand..

Let's see if the gurus can put some light on that.

73, Patrick

20

General discussion forum / Re: Winkey on COM1

« on: 2017-01-24, 20:13:10 »

Thanks Mitch,

Do i understand it right, that only COMEXTRA can be used for Winkey ?

I thought COM1 could be used for this, according to the manual :
"Mode 8 = The WinKeyer emulator is activated, and data received from COM1 are sent as CW from the Radio-RRC in parallel with the ordinary keyer."

So i have to use 2 profiles, one using COMEXTRA for Winkey and another profile with COMEXTRA for FSK ?

73, Patrick

21

General discussion forum / Winkey on COM1

« on: 2017-01-24, 17:35:33 »

Hi all,

I recently bought a RRC1258 set that i'm trying to configure.. So i'm a newcomer here...

I use my PC COM port 1 connected to the COM2 of the control box and setup to interface with my TS590s. That works, everything is just fine.
I setup the keyer and that works with the paddle.

Now i'm looking for a way to setup the Winkeyer on RRC COM1 (virtual COM13 on my PC),because i would like to use the COM3 Extra for RTTY.

I configured LOGGER32 to use COM13 for Winkeyer, but it doesn't find any keyer.

What did i make wrong ? Can't COM1 of the RRC control box be used as a Winkey in parallel with the paddle ? I RTFM and onclued that it is possible...

Or how should i configure to be able to use both Winkeyer and RTTY ?
73, Patrick TK5EP