Messages

16

General discussion forum / Re: Remoterig internal keyer

« on: 2020-07-17, 15:55:21 »

Hi Mitch, nice to hear from you.  Let me check this out.  It was painful getting the RRC's connected and working, but I'm on the air--more or less.  Several things to work on, but I'm making DX QSO's in CW.  I have a feeling I'm going to be back to the Forum.

George W1EBI/VA2EBI

17

Configuration, RRC 1258 / Re: Help configuring RRC for new user

« on: 2020-02-03, 21:00:20 »

OK, thanks, Mitch.

George W1EBI

18

Configuration, RRC 1258 / Help configuring RRC for new user

« on: 2020-02-03, 19:39:34 »

I have used a RRC for a K3/0 connecting to RemoteHamRadio stations in the New York area.  That was several years ago.  I am now working to set up a pair of Yaesu FTdx-5000's in a Yaesu Twin remote network from my Control location in Massachusetts to the Radio location in Quebec.  I purchased a new pair of RRC's and the Yaesu Twin accessory pack.  I downloaded the Setup Manager and I'm looking at the DOS screen after connecting one of the new RRC's.  My home network consists of a Linksys ACS router behind a Verizon router.  The IP address of my PC is not the standard 192.168.1.xx.  When I connected one of the new RRC's to my pc, the Autoconfig IPV4 address is quite different, and there is no Default Gateway.  And I don't know the IP address of the network in Quebec that it will be connected to.  At last, my question:  how should I change the IP's of the new RRC's for the Control and Radio end of this planned remote network?