Messages

46

General discussion forum / Re: RC 2000 - 0,1KHz step

« on: 2012-01-13, 15:14:10 »

I am using homebrew board too:

tuningknop with 5 cm diameter and HEDS-5540 #A06, optical encoder, 500 CPR, 6,35mm axle (1/4") (look at E..ay.de) wired to the encoder inside the RC 2000 panel.
The encoder use 5 Volt DC from the RC 2000.

http://www.datasheetcatalog.org/datasheets/270/77838_DS.pdf

73
Willi

47

General discussion / Re: Software for RRC-Micro PC-Client

« on: 2011-05-20, 17:28:07 »

tks, Roland

73 Willi

48

General discussion / Software for RRC-Micro PC-Client

« on: 2011-05-18, 00:21:21 »

Hi,

Does any other software works as the slow HRD with RRC-Micro PC-Client? I prefere the excellent ICOM Software RS-BA1 for my IC-7600 using C-IV Mode. At the same time I will control my rotor on COM 1 and my Expert 1K-Fa on COM 2.
Or shall I use RRC1258MKII on control- and radio-site?

tks Willi