Messages

61

General discussion forum / Re: Straight key - without paddle ?

« on: 2011-06-24, 12:36:00 »

Just measured that only OUT0 on/off works. Setting OUT1 to ON does not affect OUT1 wired output nor OU2 either (even though  the status page indicates so...) Is there still something to check in my configuration or could it be a bug? 

62

General discussion forum / Re: Straight key - without paddle ?

« on: 2011-06-23, 22:16:36 »

You can not combine them, when using CW the inputs are not available. But you can control the ouputs on the Radio-RRCs via the web interface

/mike

I had to put OUT2 to keyer to get PC keyer without paddles working. Now if I set OUT0 (on/off) to ON and OUT1 (on/off) to ON via the WEB interface the status page indicates the following:

Output 0   High
Output 1   Low
Output 2   High

OUT1 on/off seems to set OUT2 high? So I need to wire OUT0 and OUT2 to get remote switching work? Or is this a bug that will be fixed later?

73 de Kari, OH2XX