RRC 1258 Support in English > Configuration, RRC 1258

Version 2.46 Software -OUT1/2

(1/1)

g4swx:
Hi,

I have just upgraded the software on the controller and radio units to version 2.46. I spotted in the release notes: "- If you use the I/O connector, be careful OUT1 and OUT2 are swapped, they where wrong before."

I do use OUT1 and OUT2 to provide remote operation of relays from switches fed into the IN-1 and IN-2 inputs. The operation still seems to be as before ie: an input on IN-1 produces an output on OUT-1 etc, so no change. However when I set the units up I did swap the OUT wires as I suspected that I might have got the wires crossed in the following relay unit.

Have I missunderstood the release note or are there more swaps to come???

73
John G4SWX

sm2o:
Hi

There is no diffrnce in the firmware, it's only the manual which is adjusted, the pin numbering of the I/O connector was wrong.

73 de mike

g4swx:
Thanks Mike - that makes a lot of sense - I wired it up as per manual and then swapped the wires as I thought that I had made a mistake...............

73
John

Navigation

[0] Message Index