Author Topic: RRC-1258 Firmware 2.65 V7  (Read 2714 times)

iw1gap

  • Newbie
  • *
  • Posts: 17
    • View Profile
    • Email
RRC-1258 Firmware 2.65 V7
« on: 2012-11-13, 23:33:56 »
Hello,
I find it really strange that:
my device RRC Radio MkII can not communicate with RRC-Control V7.
There is a minimum compatibility between the two terminals?
The error that appears is:
CP-> Panel power on after SIP error
CP-> Panel power off two to no comm.
CP-> Panel power on after SIP error
CP-> Panel power off two to no comm.
CP-> Panel power on after SIP error
CP-> Panel power off two to no comm.
CP-> Panel power on after SIP error
CP-> Panel power off two to no comm.
CP-> Panel power on after SIP error
CP-> Panel power off two to no comm.
CP-> Panel power on after SIP error

the doors, on firewall, are open, the cable for ic2820 is ok (i13a).
Any ideas please?

thanks
Andrea
Andrea IW1GAP
http://server.ham.radio.it
mail:iw1gap(@)ham.radio.it

la8jra

  • Newbie
  • *
  • Posts: 3
    • View Profile
    • Email
Re: RRC-1258 Firmware 2.65 V7
« Reply #1 on: 2012-12-08, 14:31:54 »
Have the same problem (IC-E2820). I have not tested lower versions of firmware, but i will try to downgrade.
Another detail is that the green light (back light in buttons) in the mic is turning on and off.

The radio will not turn on, and the following messages are comming on the telnet port from the controll unit, but noting is happening on the telent port for the Radio unit.


CP-> Panel power off due to no comm.
CP-> Panel power on after SIP error
CP-> Panel power off due to no comm.
CP-> Panel power on after SIP error

Hope for som hints!

Thanks