RRC 1258 Support in English > Configuration, RRC 1258
Remote Rig + ERC + Com1?
M1EMB:
Hello
Hope some of you Remote Rig owners might be able to help me please. I am
looking to use the ERC (Easy Rotator Controller) with my RR setup but I have used Com2 with a Cat
interface for IC706mk2G.
Speaking to Mike he said that com1 is the same as com2 only the pin config is different from com2 in the radio box, it's a female dsub and pin 2 and 3 are shifted compared to com2.
Has anyone managed to setup Com1 with the ERC?
Thank you
Stu
HL5KY:
Hi Stu,
I got a personal message from you but I thought this is a better way to answer your question.
Here I give you my setp and connection of ERC-M and RRC.
RRC Setup
COM1 (ERC) Mode-3, 9600, 8, 1, 0, cts/rts(no), terminator(00)
(You can change buad rate of ERC with setup software of ERC, Service Tool)
Computer - Control RRC
pin2 - pin2
pin3 - pin3
pin5 - pin5
ERC-M - Radio RRC
Tip - pin2
Ring - pin3
GND - pin5
Good luck.
Joe, HL5KY.
M1EMB:
Hi Joe
Sorry for the delay, thank you very much for your help with the ERC connections, I have it all wired up and have double checked the connections but keep getting the message "no erc answering on port com1" , did you have any teething problems when you got it setup? I have the ERC all wired as per your guide going to the com1 on the radio RR and downstairs I have the serial cable going from com1 to the PC's com1 serial connection.
For the RRC Setup serial connections that you gave me is this just for the control side? What about the radio serial side, I tested it both ways but can't get a answer from com1, just about to get a serial to USB cable to see if that makes a difference.
Any ideas?
Thank you
Stuart
M1EMB:
Just a quick update, I had my doubts about my ERC interface so I wired pins 2 and 3 back around again and tested it and it does work, no problems reading and calibrating so its something to do with the RR that I can't see right now. Not sure if this makes a difference but I am using it over my Lan at the moment whilst setting the rotator and ERC/RR up. Does that help anymore?
Thank you
M1EMB:
OK guys, I have it, wrong setting on the radio side, thanks for the help getting this sorted, looking forward to getting it live.
Thanks Stu
Navigation
[0] Message Index
[#] Next page
Go to full version