Author Topic: COM1 Pinout with SPE2K amps  (Read 8690 times)

K1UO - Larry

  • Jr. Member
  • **
  • Posts: 48
    • View Profile
    • Email
COM1 Pinout with SPE2K amps
« on: 2015-11-07, 22:34:06 »
Does anyone know which pins to connect up on RRC COM1 port to use with the SPE2K.   Is it 2,3 and 5 or 7,8 and 5?    It looks like SPE uses 7,8,5 on their end for Remote control.    Chances are it is 7,8 and 5 but not 100% sure.

Larry  K1UO
« Last Edit: 2015-11-07, 23:14:09 by K1UO - Larry »

dj0qn

  • Hero Member
  • *****
  • Posts: 2223
    • View Profile
    • DJ0QN / K7DX
    • Email
Re: COM1 Pinout with SPE2K amps
« Reply #1 on: 2015-11-07, 23:17:03 »
Larry,

That is correct, SPE uses pins 7 & 8 instead of 2 & 3, since those pins are used for SteppIR control.

73,
Mitch DJ0QN / K7DX

sm2o

  • Administrator
  • Hero Member
  • *****
  • Posts: 3041
    • View Profile
    • sm2oan
    • Email
Re: COM1 Pinout with SPE2K amps
« Reply #2 on: 2015-11-07, 23:43:38 »
Here are the instructions and cable drawings

http://www.remoterig.com/wp/?page_id=426#tabs-2

73 de mike

K1UO - Larry

  • Jr. Member
  • **
  • Posts: 48
    • View Profile
    • Email
Re: COM1 Pinout with SPE2K amps
« Reply #3 on: 2015-11-08, 04:12:05 »
Got it and thanks for the instruction sheet..Had not seen that before.  Should be good to go now.

Larry  K1UO

M0BPQ

  • Jr. Member
  • **
  • Posts: 50
    • View Profile
    • Email
Re: COM1 Pinout with SPE2K amps
« Reply #4 on: 2016-10-26, 14:25:39 »
Thanks for posting this - just what I needed! Steve