RRC 1258 Support in English > General discussion forum

Switching between PC-Client and TS-480 Control Head?

(1/2) > >>

NZ5E:
I currently have the 2-box Remoterig system connected in Mode 5 to a Kenwood TS-480.  If I add the PC-Client hardware/software, can I leave the Remoterig Radio Unit in Mode 5 and operate with the TS-480 Remote Head at my home and the PC-Client on my laptop from other locations without reconfiguring everything?

I realize that I can download the PC-Client software from the website.  What are my options for purchasing the hardware?

dj0qn:
Just make sure that you leave your head turned off when you leave
and the RRC setting "auto connect" to "no", and you will be fine.

73,
Mitch DJ0QN / K7DX

ZL4PLM:
Mitch

what would be the setup on the RRC for this

I have the same setup Id like to try

dj0qn:
Just go into the box (control side) and go to "Radio Settings". Then
make sure that "Auto connect" is set to no.

That's all there is to it, except making sure that your remote head is off.

I have played around and been able to get control using the PC Client,
even when the head was connected, but I would not recommend this.

73,
Mitch DJ0QN / K7DX

ON4AOI:

--- Quote from: dj0qn on 2010-11-30, 11:43:46 ---I have played around and been able to get control using the PC Client,
even when the head was connected, but I would not recommend this.

--- End quote ---

Not sure if this can be problem Mitch, if you use the original kenwood soft it works also perfect
maybe you can have some timing problems if you use a different network provider (GSM + internet)

Guy ON4AOI

Navigation

[0] Message Index

[#] Next page