RRC 1258 Support in English > General discussion forum

Kenwood ts-480 Sat

<< < (3/4) > >>

K0ATZ:
It has a ethernet box at each end with fiber ran between the boxes, which ties into the Rig Remote boxes.

dj0qn:
I am still not sure what you did wrong. The strange thing is that the setup as far as the RRC's are
concerned is virtually identical to what you had before. Except for a few cables and one setting in the
RRC's (and one jumper in the control RRC), there should have been no changes necessary. All the
network and SIP settings, etc. should have been left as is.

I would revert back to how to had it working before and start from scratch. Once you have it working
again, just make those couple of changes and it should work just fine.

73,
Mitch DJ0QN / K7DX

K0ATZ:
What is the one setting you are talking about?  I did the jumper wires and the the jumper pins?  as described on page 185 our IT guys checked my work and they said it looked correct per the paper.

dj0qn:
The only setting that needs to be changed is program mode=5.

73,
Mitch DJ0QN / K7DX

K0ATZ:
So do you have to have the boxes hooked up to a computer to do that program change? Sorry I wasn't here when this was installed and am not familiar with this at all.

Navigation

[0] Message Index

[#] Next page

[*] Previous page