RRC 1258 Support in English > Configuration, RRC 1258

Change of ISP at Remote Site - Help Requested

<< < (3/3)

dj0qn:
I am not sure what you mean by "communicating with each other". Are you saying that the status is
showing all connected OK? Do you receive the single connect beep?

I would take a look at the power supply the control RRC is using. Sounds like the head is not receiving
enough power in that case. Unplug the USB cable when testing to make sure.

73,
Mitch DJ0QN / K7DX

Mike Cotton - K4RUM:
Yes; the Control RRC status indicates that the radio is on.  Both the Control and Radio RRCs SIP status indicate connected/transferring.  I do not hear a beep, which does suggest that the head is not getting enough power.

I changed the power supply to the Control RRC (twice); the radio head still does not turn on.

dj0qn:
I have only seen this happen in two cases:

1) The TTL cable was using a standard telephone cable instead of the 6P6C cable that is necessary.

2) Or the power supply was not producing enough voltage.

If these are both fine on your side, then I am not sure what it could be. If you want, you can e-mail me directly
and send me your .BIN config file for the control RRC and I can try it from here. At least then we can determine
where the problem lies.

73,
Mitch DJ0QN / K7DX

Mike Cotton - K4RUM:
OK Mitch.  I'll email you my .BIN file for my Control RRC.

I am not using a telephone cable.

Thanks very much.

Navigation

[0] Message Index

[*] Previous page