Webswitch 1216H Support in English > Hardware, Cabling, Installations

1216h+1216L cabling for kenpro/yaesu 650


Hi guys,

I'm looking at some cabling instructions to connect the 1216L rotor controller to a KENPRO 650XL (YAESU G-650).

I have found some schematics and as far as I can see CW and CCW should go to 4 - 5 - 6 pin on the rear of the control box
and Pin 2 - 3 should connects to POT input of the controller.
No brakes control line (not present)

Is that correct ? any advice ?

Thank you
73 de IW2DOY Edoardo


[0] Message Index

Go to full version