Webswitch 1216H Support in English > Configuration, Webswitch 1216H
RC 1216 with Expert 1.3 non connecting
w2hdi:
I just installed a new RC1216H for the purpose of remote control of my Expert 1.3 amp. I had purchased the cable from Expert when I bought the amp a few years ago.
Installation of the RC1216 seems to be working, and I'm showing the screen for the amp, with a flashing green light. But I have no response when I connect the cable to the amp. I've re-read instructions for both the amp com port and the RC 1216. Can't figure out what I'm doing incorrectly. Wondering if I have a bad cable.
dj0qn:
Check to make sure that the serial end of the cable is using pins 7&8 instead of 2&3, which are the
standard pins. The Expert uses 7&8 for CAT, because 2&3 are reserved for a SteppIR controller.
73,
Mitch DJ0QN / K7DX
w2hdi:
Is the "serial" end the male end, as in the manual. I'm seeing Female(2,3,5) and Male (5,7,8)
Thanks
dj0qn:
That is correct.
My only guess is the baud rates don't match, otherwise Mike or someone may have a better idea.
73,
Mitch DJ0QN / K7DX
sm2o:
Hi first question when people having trouble with Expert is. Have you disconnected the USB-cable from the PA ? When connected it disables the serial port
I don't know anything about the cable from Expert. Check it against our manual, you also need the start signal connected via SW1.
http://www.remoterig.com/downloads/Ba-RC1216H-A15_v4.59.pdf
73 de mike
Navigation
[0] Message Index
[#] Next page
Go to full version