Author Topic: Webswitch Scrambled by power spike  (Read 545 times)

wb7ely

  • Jr. Member
  • **
  • Posts: 52
    • View Profile
    • WB7ELY
    • Email
Webswitch Scrambled by power spike
« on: 2021-03-31, 05:58:39 »
Appears my functioning webswitch was scrambled by a power failure and resulting spike. Subsequent power back-on at the remote site revealed a tough problem. I am able to control the relays but they return to their relaxed position a few minutes later. I recently arrived at the remote site and figured I could just connect to the webswitch with my laptop using the USB connection and use the setup manager to reset everything but it does not respond to the setup manager. Some of the other screens are also scrambled. Check this link to view my screenshots: http://www.valhallatreefarm.com/WB7ELY/websw/webswprob.htm
Any suggestions would be greatly appreciated.
de Dave
WB7ELY
//Dave WB7ELY

wb7ely

  • Jr. Member
  • **
  • Posts: 52
    • View Profile
    • WB7ELY
    • Email
Re: Webswitch Scrambled by power spike
« Reply #1 on: 2021-04-05, 04:58:42 »
It appears the webswitch wants a username and password to make any changes to its configuration. If you have failed to note your username and password, there must be a way to recover it even if its a full reset.
//Dave WB7ELY

sm2o

  • Administrator
  • Hero Member
  • *****
  • Posts: 2796
    • View Profile
    • sm2oan
    • Email
Re: Webswitch Scrambled by power spike
« Reply #2 on: 2021-04-05, 11:15:45 »
Under the advanced tab in the Setup Manager you can "set default settnings" do remove the password

/mike