Webswitch 1216H Support in English > General discussion forum
Stange LAN behavior
K5WA:
Mikael,
I have a pair of RC-1216H on my ACOM 2000A amps and a WS-1216H for general power control. They have worked well for a long time. Recently, I see that only the RemoteRig devices on my LAN are very inconsistent in presenting their webpage or reacting to a button push. I have tried changing the IP addresses and port numbers to see if that was in conflict and I have tried DHCP to see if that would help instead of static IP. Nothing I've tried so far has fixed the problem.
Can you think of any reason why ONLY the RemoteRig devices would be very sluggish or non-responsive on my LAN? The password check seems to come up perfectly but after that, non-responsive or VERY slow (maybe 30-45 seconds to load a page).
Thanks,
Bob K5WA
vk3ga:
I had the same problem with 3 x WS-1216H. In the end I had to downgrade to the previous firmware version.
73 Graham VK3GA
JI1HNC:
Graham-san;
I have the same problem on RC1216H and SPE 1K-FA pair recently.
Which version of firmware do you use?
I am still using v.4.26.
Regards,
Akira
JI1HNC
vk3ga:
Akira,
I found that 4.59 and 4.7 did not work. I reverted back to 4.27.
I'm not sure why 4.26 does not work. Try upgrade to 4.27 perhaps.
Good luck,
Graham VK3GA
JI1HNC:
Graham-san;
Thank you for your advice.
I went to the remote shack and updated to 4.27 over weekend.
It seems somehow improved but not drastically.
Also, I noticed that RC1216H was just like "breathing" about
every 10 seconds to send 1K-FA's control view.
I will let you know when I find out the cause.
73
Akira
JI1HNC
Navigation
[0] Message Index
[#] Next page
Go to full version