RRC 1258 Support in English > General discussion forum
Icom 7300 and Remoterig
Mitch:
I have been working my Kenwood 480 for many years now with the RRC-1258MkIIs.
Would like to update the radio to my Icom 7300 would this be supported by Remoterig.
Have looked for post's in the Furum and can't see anyone that has got it to work for them.
73S
sm2o:
All Icom Radios with a traditional CI-V Interface can be used with Remoterig
73 de mike
Mitch:
Many Thanks,
Mike just need to try find the link to configuring jumpers in each box. I have RS-BA1 Version 2 and Win4IcomSuite would you know if this would work with PC at radio side + control side for the waterfall.
73s de Gary
sm2o:
The jumpers is only for the mic signal, check the Chapter ICOM IN General.
I doubt any waterfall info is sent over CI-V.
/mike
Mitch:
Thanks Mike,
Would you know what cable's I need from the Icom 7300 to RRC-1258MkII radio side.
And the cable needed again from the RRC-1258MkII to my laptop at the control side.
73
Navigation
[0] Message Index
[#] Next page
Go to full version