RRC 1258 Support på Svenska > Konfiguration av RRC 1258

RRC1258, K3/0 mini no SSB output

<< < (2/2)

cx6vm:
hello

finally I have time to go to the remote site

I took MH2 Elecraft microphone

I tested on local K3, a radio that is alone to do radio directly from the contest station, and it works OK.

Then I connected the MH2 on the K3 that I use to do remote, it was ON and MH2 was working perfectly, going full power output

Then I arrive at home, connected the MH2 microphone on the K3/0 mini, and doesn´t work?

No idea what is wrong

Bottom of the line, now I cannot TX on FT8!, I need to review what I modify on the K3 menu that is not TX. Radio go on TX but no output

thanks!
Jorge
CX6VM/CW5W

sm2o:
if you have the orginal Elecraft cables I think it's connected to the back mic connector so you need to switch back to rear mic in the K3 setup

By the way It's better to connect the mic direct to the Control-RRC, Less noise

email me export settings(html) files from both units to support@remoterig.com

/mike

cx6vm:
Hello Mike

yes, I have the original Elecraft cables

today I finally set MIC SEL to rP.H, this was the way to do FT8 that also was not working yesterday after the changes I did

I am emailing both files to you

thanks!

Jorge

Navigation

[0] Message Index

[*] Previous page