TS-590S Twin Baud rate

[HB9BJL]

I have a TS-590 Twin setup with a internal Baud rate of 9600 Baud. So far. the response from the TS-590S twin setup is very slow.
The COM0 setting for the TS-480 is 57600 Baud. What is the maximum practical Baudrate for a TS-590S Twin setup ? In the manual, page 209, 19200 Baud has been selected.
73 de Christian, Hb9BJL

[sm2o]

You can use whatever baudrate you want but you have to set the CAT baudrate in the Radios and the Remoterig to the same baudrate. Never heard that 19200 is to slow I think the problem is high latency internet connection not the baudrate

73 de mike

[HB9BJL]

Hello Mike

point taken - I have set all Baud rates to 57600 (maximum possible). I think there is a small improvement. You are right, the problem is the latency over the internet connection. To make things worse, I can only connect via 4 G / LTE at the remote site and the 4G base station is very busy with cars driving on the nearby highway. No fibre optic installation in the near future (legal disputes). But it is better to have a bit of blinking during updates than nothing. My second station with a TS-480SAT is responding a lot faster so I use this rig most of the time. The receiver gets overloaded in the evening with strong signals and then it is time to go to the TS-590S, what a difference !
73 and tnx de Christian