Topics

1

General discussion forum / Problem with I/O pins

« on: 2016-09-01, 17:35:27 »

Hi all,
while trying to control my Acom amplifier using the I/O output lines, I found two big issues.
On the Radio side, pin definition on the WEB interface is swapped, i.e. OUT0 controls Output 2 and OUT2 controls Output 0.
Moreover in the WEB status page Output 1 and Output 2 are also swapped.
I got crazy for a week not being able to understand why I couldn't control the amplifer (of course I added pull-up resistors to 8V).
Anybody else faced this issue?

Regards
Alberto I2KBD

2

Configuration, RRC 1258 / TS-480 CAT one way

« on: 2016-02-15, 12:50:37 »

Hi everybody,
I am using Commander (DXLab suite) to control the CAT of my TS-480.
Radio RRC to COM2 and Control RRC using the USB port.
Commander controls the radio with no problem (frequency and mode) but cannot receive frequency from the rig, when I move the dial manually. There seems to be a problem in receiving data from TS-480 CAT, but sending is ok.
PC is running Windows 10.

Any suggestion?
Alberto I2KBD