RRC 1258 Support in English > Configuration of Routers, Firewalls, etc
icom ic 7100 problem after change adsl "solved"
oz1rh:
Sri Rodolfo, I am not sure I understand your problem. Is the new fiber net router at the radio site or at your control site? I thought it was at your radio site, but now you write that all works when using a 4G/LTE router at your control site. That make me think the fiber net router is also at your control site. Maybe AGL (and SIP?) has not been disabled in the new fiber net router? Any firewall in your fiber net router?
The ports opened in my remote (radio site) router 13.000-13.002 are the same ones I see in both my control RR-1258 and radio RR-1258 when connected. All my RR-1258 have firmware 2.91 (the newest as of today).
If I understand it correctly you are only able to use your own remote 7100 after connecting to another 7100? Is this only when using the fiber net router at your control site? That would point to a problem with the fiber net router (AGL?). Are you sure you use the correct profile when trying to connect to your own remote 7100? And have you booted=reset your control RR-1258 after changing profile? That reset should be automatic after changing profile. Perhaps your control RR-1258 starts with a wrong profile after switching it on? Try selecting the right profile and resetting it right after power on. Since all worked before you got the fiber net router this should not be your problem.
73, Palle, OZ1RH.
ik4vfd:
the new fiber is on my radio site, in control site i use a normal ADSL, linking it to rrc with wifi...
in control site i switch from adsl to 4g and all work fine...
if i switch to another profile with another ic 7100 it start after e select my profile and after reset all work fine... but when I turn off and after some time, tried again to turn on the radio, once again yellow light fix but the front does not light up
oz1rh:
Seems your new fiber net router is not the problem as remote works when you do certain things at the control site. As I understand it something at the control site remembers what you have done before. I can't think of anything else than the profile in RR-1258. Though firewalls can remember sessions that is not likely for firewalls in consumer routers.
You should publish how the whole status page of your remote RR-1258 and the control RR-1258 look like when you have the problem. Any errors may point to what the problem is.
73, Palle, OZ1RH.
ik4vfd:
thanks for the answers ... no error is present in the status ... the only difference I've posted above ...
it's a mistery
rodolfo
dj0qn:
Rodolfo,
What are the status messages on the status page on both RRC's when attempting a connect?
Assuming you forwarded the ports correctly in the new router, the problem could also be caused by:
- Make sure that the ports are forwarded as UDP and not TCP
- Did you make sure that SIP ALG is off on the new router?
- Try turning off the new router's firewall to see if that helps
- Are you sure you have a true external IP address on the new provider? See http://www.remoterig.com/wp/?page_id=3494
73,
Mitch DJ0QN / K7DX
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version