1
General discussion forum / Cannot access control RRC
« on: 2011-01-18, 12:28:52 »
When I do microbit set up via USB, the IP address of the control unit is as expected.
However, when I do the cmd:ipconfig, an IP address of the Control unit is something different.
I tried to download the firmware and it failed to write. .30 is the version.
It is as if something is corrupted in the control firmware that is preventing me to communicate via LAN even though the IP address via USB is fine.
Cannot bring up the status etc, is there another way to configure the ctl, rather than using the LAN connection?
The LAN connection appears to be unoperational.
Not sure why the microbit setup has one IP address and the cmd:IPconfig has a different address.
Any ideas, especially on how to reload the firmware without a failure to write.
However, when I do the cmd:ipconfig, an IP address of the Control unit is something different.
I tried to download the firmware and it failed to write. .30 is the version.
It is as if something is corrupted in the control firmware that is preventing me to communicate via LAN even though the IP address via USB is fine.
Cannot bring up the status etc, is there another way to configure the ctl, rather than using the LAN connection?
The LAN connection appears to be unoperational.
Not sure why the microbit setup has one IP address and the cmd:IPconfig has a different address.
Any ideas, especially on how to reload the firmware without a failure to write.