Show Posts
1
General discussion forum / Using FT8 and JT65 over remoterig with IC7100
« on: 2018-04-12, 18:29:25 »
Hi,
I have my IC7100 connected remotely using remoterig and all is well for Phone but what about digital modes like FT8?
At my house, I have a radio connected to my PC running Windows, HRD, WSJT-X and I run my digital modes from that without any issue.
I have also connected my remote radio (IC7100) to HRD and HRD can operate the radio but how do I configure it so I can use digital modes?
Remote station is operated via RRC-1258MkII and CI-V Interface at the PC end (My house), I have a PC running HRD and WSJT-X and the connection between the PC and the 1258MkII is via USB at the remote site the only connections are the 1258MkII,m network cables and the power and aerial.
What do I need to do to run digital modes over this setup?
I'm open to any suggestions.
73
I have my IC7100 connected remotely using remoterig and all is well for Phone but what about digital modes like FT8?
At my house, I have a radio connected to my PC running Windows, HRD, WSJT-X and I run my digital modes from that without any issue.
I have also connected my remote radio (IC7100) to HRD and HRD can operate the radio but how do I configure it so I can use digital modes?
Remote station is operated via RRC-1258MkII and CI-V Interface at the PC end (My house), I have a PC running HRD and WSJT-X and the connection between the PC and the 1258MkII is via USB at the remote site the only connections are the 1258MkII,m network cables and the power and aerial.
What do I need to do to run digital modes over this setup?
I'm open to any suggestions.
73