No audio packets

[aj1y]

I am using the 1274A dongle attached to a Windows 11 PC with the 1258MKII at the radio site (Elecraft K3).  I have no audio packets arriving at the PC - the green bar is blank.  I am at my home on the same LAN. 

I also have a Windows 10 PC using the same configuration for both in the RRC and the 1274A and it has audio packets without any problems.  It functions normally within the local LAN or outside.

Does anyone have any ideas as to how I can fix this problem?  Here is a copy of the RRC Status when HRD is connected via the 1274A Com port:

Status

Name   Value
P5.2   OFF
Connection status   OK
SIP status   Connected/transfering
Last SIP error   None
RTP status   Excellent(60)
UDP cmd status   OK(45)
SIP command timeout   0
Rx Jitter buffer size   12
Rx Jitter delay   10
Dual Rx   0
Current audio packet size   20
Current audio quality   0 - alaw 8 kHz
External IP   72.93.241.136
SIP Out port   51200
SIP In port   51200
Audio Out port   51201
Audio In port   51201
Command Out port   51202
Command In port   51202
External SIP In port   51200
External Audio In port   51201
External Cmd In port   51202
Other party   192.168.1.152
Input 1   High
Input 2   High
Output 0   Low
Output 1   Low
Output 2   Low
Dynamic DNS status   OK
Ping status (watchdog)   Off
DNS status   OK, remoterig.com = 86.107.103.218
Active profile   Default
PTT status   OFF
Antenna-Switch (IP)   not connected
Common network settings   No

Thanks,

Joe
AJ1Y

[aj1y]

I finally have audio from the remote K3 to the laptop at the control site but while I have audio with a headset using through the jacks in the dongle and via a USB headset, I cannot figure how to get that audio to computers speakers on this Windows 11 computer.  I have it working fine on the Windows 10 pc.  Any ideas as to how set up the Sound Settings in Windows 11 to do that? 

Thanks,

Joe