Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - SM6WCQ

Pages: [1]
1
General discussion forum / Re: RRC behind 3G / UMTS
« on: 2010-04-05, 22:42:49 »
Have you made sure that you have a public IP address at your remote QTH?
If you have an IP address that is not public you will not be able to access anything behind your 3G router since all traffic is routed through a SW router in the 3G operators network.
73 / SM6WCQ - Markus

2
General discussion forum / Re: Remote Rig in the USA?
« on: 2010-02-15, 12:07:49 »
Hi guys!

Mike has a list of reference installations at www.remoterig.com
Take a look at http://www.remoterig.com/en/references.htm
At least the conclusion can be drawn that a number if systems have been sold to the U.S...

If you're hesitant whether to buy the RemoteRig boxes; don't be! It's a wonderful product!
I'm using it with my FT-857. It does not work with the FT-857 front panel at the control side (due to yaesu implentation of communication between front panel and radio), but I use it with HRD and have the mic/speaker in my hand. It works like a charm. The delay is so small that I dont have to worry about holding the PTT for an extra couple of seconds or so. It really works as if I were in the schack.

Perhaps it sounds like I'm getting payd to say this, but I don't. I'm just glad that I can work HF/VHF/UHF despite the fact that I live in a small town with a lot of shortwave noise and almoust sorrounded by mountains...

But as usual: do your own homework and decide if you like it or not. Surf around the website, very good information to be found there. I don't think that there are any dealers in the U.S. yet, but I found this on the website http://lab.microbit.se/webshop.int/ (linked from remoterig.com and is only about the RemoteRig product):
"Freigth costs will be added to the price : USD 35"

Good luck!

/Markus -SM6WCQ

3
Hårdvara, Kablage, Installationer / Stereo eller mono?
« on: 2010-02-14, 20:28:01 »
Tja!

Har en RRC1258MKII som jag köpte för halvannan vecka sedan. Jag har bara ljud i ena hörluren i kontrolländen trots att jag matar in ljud i både höger och vänster. Är det helt i sin ordning?
Det är ju rimligt att anta att det ska vara stereoljud eftersom dokumentationen på RemoteRig.com tydligt anger att man ska ansluta en vanlig 3,5mm stereokabel mellan radio och radio-RRC.

(Och ja, jag har kollat att hörlurar, stereokabel och ljudet från radio är som det ska.)

Bitte hilfe!

73!
/Markus -wcq

Pages: [1]