Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Techdude

Pages: [1]
1
General discussion forum / Farenheit instead of Celsius
« on: 2012-08-31, 01:59:45 »
Is there a way to see temp readings in Fahrenheit instead of Celsius? Not too big of a deal to convert... Just wanted to ask....I'm using the heat/cooling control with the temp sensors... I'm also using the 1216L for remote controlling my hexbeam along with the relays for other stuff. My webswitch works terrific never an issue.
Thanks

2
Good Morning
I recently purchased and setup a remoterig system. I'm using a Kenwood TS2000X with a RC-2000 controller. Both the radio & the control units are on the same network. The problem is that when I press power on the controller (RC-2000) I hear a beep but nothing powers up. If I manually turn on the rig The controller (RC-2000) stays off but everything else audio & PTT work fine. If I connect the controller direct to the rig... the controller works correctly so believe its not a cable issue. It's like the remoterig will not pass the signal through the TTL port. I've tried holding the power button down longer but no luck. When I transmit I can hear my audio through the speaker I connected to the remote side. Both units have 2.54 software. I've rechecked jumpers & settings. Any help is appreciated.
Scott
KJ6NRO

Pages: [1]