Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - k6rgi

Pages: [1]
1
Hardware, Cabling, Installations / SignaLink pass-through using AUX/MIC only?
« on: 2016-10-06, 22:50:48 »
A search here doesn't specifically address this issue - I'd like to connect a SignaLink at the control RRC using only the AUX/MIC on both RRCs.  This would be the cleanest cabling option.  There are only four needed signal lines: TX audio, RX audio, ground, and PTT.  These would be passed to 6-pin mini DIN on either a Kenwood TM-V71A or Icom IC-7100 for fldigi and other digital software.  Are there any special configuration or latency issues I should be aware of?
Thanks,
Rob K6RGI

Pages: [1]