Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - W9JH

Pages: [1]
1
General discussion forum / RC-1216H with Elecraft KPA500
« on: 2020-10-02, 21:08:23 »
I don't have the RC-1216H yet but after reading the setup instructions I don't see any comments about the KPA500 Menu settings. In particular the RS-232 baud rate.

Do you just leave the baud rate at the default setting = 38400?

73,
Jack
W9JH

Pages: [1]