Messages

1

General discussion forum / Re: USB0 disconnects. Requires RRC reboot to recover

« on: 2011-10-17, 19:42:48 »

Hi Jan,
We tested everything with guys yesturday.
The USB port is freeze's with YAESU  FT817 radio also.
We checked the input and output datas.
Was no problem, but after 5...10 minuts the CAT is stopped.
Must be switch off and on the control RRC and  it is going again up some mins.
If your side  this setup  works fine seems any problem  only in our RRC control box.
I will send it back to repair or change.
We experimented with RRC more than 40 hours, and we checked yet  every possibilities.
73, Gabi HA1YA

2

General discussion forum / Re: USB0 disconnects. Requires RRC reboot to recover

« on: 2011-10-15, 13:04:02 »

Hi Jan,
You tested it with HRD and ICOM CI-V?
Maybe the problem only on case ICOM commands?
We will try out the same installation with another ( YAESU) radio.
73, Gabi

3

General discussion forum / Re: USB0 disconnects. Requires RRC reboot to recover

« on: 2011-10-13, 20:00:41 »

Hi,
I have similar problem  with my IC746 when I use the USB input on the control RRC to CAT.
I tested the USB with com0com and VSPE without sucess.
In the first seconds everything works fine but after some seconds to up to 10-15mins the CAT is freeze's.
If I restart the HRD and the control RRC start to work again fine up to some time.
No problem with the audio, tx etc.
If I using  RRC Micro from same usb port,  it works fine..
Tested different PC's, different ICOM746 etc..
Seems the problem with the RRC control USB, or with the RRC  ;DUSB hardware?
I am after 20-30 hours experiments without results.
If I using the COM2 of the RRC over USB/RS232 converter everything works well.
73, Gabi