RRC 1258 Support in English > Configuration, RRC 1258

Web Interface Failure

(1/1)

VE7GTC:
Hello All,
Many months ago everything worked, but the system was moved, and now it's hair pulling time. I can plug in the USB cable and get the net info and it shows the proper IP and gateway. However, if I click "Browse unit" the web browser opens up and fails to connect. This happens with both the radio and control units. About 1 out of every 20 tries it connects, but only for a few seconds. Any suggestions?

Thanks,
  gus  ve7gtc

dj0qn:
Gus,

Did you change the web port number? If so, you need to add that to the browser address,
followed by a colon and port number, e.g. http://192.168.Y.YYY:XXXX (where YYYY is the
internal IP address and XXXX is the port number).

73,
Mitch DJ0QN / K7DX

Jan (Microbit):
Also worth checking is that you don't have any IP address conflicts, as that could lead to "reply/connect only sometimes" behaviour.

VE7GTC:
Thanks for the help. Problem(s) solved. While looking for an IP conflict I realized there was a second router, once used as a bridge, still running. Unplugging that fixed the network issue. Next issue turned out to be a defective Kenwood cable from the control head to the 1258. You guys got me pointed in the right direction. Thanks again.

Gus  ve7gtc

Navigation

[0] Message Index