Author Topic: Automatic Turning of Green Heron Ham IV  (Read 2733 times)

K5WK Ken

  • Jr. Member
  • **
  • Posts: 59
    • View Profile
    • Email
Automatic Turning of Green Heron Ham IV
« on: 2013-11-14, 17:20:48 »
My "problem" with turning a Green Heron motor is minor, but I have not found a solution.
When I bring up the website for the rotor, it automatically starts turning to 45 degrees.
All I want to do is stop the turning until I input a value and start the rotor on my own.
I bet the answer is easy ... but I have not found it.

sm2o

  • Administrator
  • Hero Member
  • *****
  • Posts: 2853
    • View Profile
    • sm2oan
    • Email
Re: Automatic Turning of Green Heron Ham IV
« Reply #1 on: 2013-11-15, 08:25:41 »
Hi, It should not be like that. Can you setup portforwarding of port 23 for telnet (TCP) to the the webswitch and email us the ip address etc that we need to connect to the webswitch from here. We will use telnet to check the communication with the Green Heron.

73 Mike