Author Topic: IC-7100 JMP-2 conflicting information in manual  (Read 4727 times)

bill_KE5XV

  • Newbie
  • *
  • Posts: 1
    • View Profile
    • Email
IC-7100 JMP-2 conflicting information in manual
« on: 2021-03-23, 18:21:10 »
There are two statements in the manual that are in conflict. This is for the Control box.

Page 23 the manual says -- JMP-2 is used to select if the DC-power to the front panels should be 8 or 9 V. With the strap in place it will be 8V, which fits all ICOM radios.

On page 108 for the IC-7100 the jumper table shows a '0' (not installed) for this radio.

Which of these is correct?

Thanks and 73, Bill, KE5XV


sm2o

  • Administrator
  • Hero Member
  • *****
  • Posts: 3041
    • View Profile
    • sm2oan
    • Email
Re: IC-7100 JMP-2 conflicting information in manual
« Reply #1 on: 2021-03-24, 14:51:16 »
Both is OK as the voltage is regulated inside anyway, but leave the jumper there to get 8V.

added:

I checked the manual and it says it should be there, it's on page 109 I guess you have a old manual

73 de mike
« Last Edit: 2021-03-24, 14:54:38 by sm2o »